Jeep 2013 Wrangler - Manual (Page 212)

Front Panel(s) Installation With Rear Hard Top
Removed
1. Turn the left and right panels over and move the
spacer block (located on the rear of the panel) upward
90 degrees.
NOTE: The front panel(s) must be positioned properly
to ensure sealing. Set the panels on the windshield frame
so that there is no overhang. Also, make sure that the
panels are sitting flush with the body.
2. Install the right panel first, then the left panel.
3. Reinstall the panel(s) using the same steps for removal
in reverse order.
Rear Hard Top Removal
1. Remove both front panels. Refer to “Front Panel(s)
Removal” in this section.
2. Open both doors.
3. Remove the two Torx
௡ head screws that secure the
hard top at the B-pillar (near the top of the door) using
a #40 Torx
௡ head driver (Four–Door Only).
210 UNDERSTANDING THE FEATURES OF YOUR VEHICLE