CyberResearch CPEN GX-333-X - Manual (Page 62)

CPEx GX-333-X CyberResearch
®
CPU Cards
60 ©Copyright 2007 CyberResearch, Inc.
The Boot Other Device option determines whether the SBC will use a second or third boot
device if the first boot device is not found.
Î Enabled (D
EFAULT ) The system will look for second and third boot devices if
the first one is not found.
Î Disabled The system will not look for second and third boot device
if the first one is not found.
Î Swap Floppy Drive [Disabled]
This option allows you to change floppy drive designation (drive A: or B:) without changing the
physical cabling.
Î Boot Up Floppy Seek [Enabled]
During the POST, BIOS will determine if the floppy disk drive installed has 40 or 80 tracks. 360K
FDDs have 40 tracks while 760K, 1.2M and 1.44M FDDs all have 80 tracks
Î Enabled BIOS searches for a FDD to determine if it has 40 or 80
tracks. Note that BIOS cannot tell the difference between
720K, 1.2M or 1.44M drives as they all have 80 tracks.
Î Disabled (D
EFAULT ) BIOS will not search for the type of FDD drive by track
number. Note that there will not be any warning
message if the drive installed is 360K.
Î Boot Up Numlock Status [On]
The Boot Up Numlock Status option allows you to determine the default state of the numeric
keypad.
Î Off The keys on the keypad will be arrow keys
Î On (D EFAULT ) The keys on the keypad will be number keys
Î Typematic Rate Setting [Disabled]
Disabling the Typematic Rate Setting configuration option only allows one character to appear
onto the screen if a key is continuously held down. In other words, the BIOS will only report the
key is down. When this option is enabled, the BIOS will report as before, but it will then wait a
moment, and, if the key is still down, it will begin to report that the key has been depressed
repeatedly. Such a feature would be used to accelerate cursor movements with the arrow keys.
Î Disabled (D
EFAULT ) Disables the typematic rate
Î Enabled Enables the typematic rate
Î x Typematic Rate (Chars/sec) [6]
The Typematic Rate can only be configured if the Typematic Rate Setting is Enabled. The
Typematic Rate configuration field determines the rate keys are accelerated.
Î 6 (D EFAULT ) 6 characters per second
Î 8 8 characters per second
Î 10 10 characters per second
Î 12 12 characters per second
Î 15 15 characters per second
Î 20
20 characters per second