CyberResearch CPEN GX-333-X - Manual (Page 70)

CPEx GX-333-X CyberResearch
®
CPU Cards
68 ©Copyright 2007 CyberResearch, Inc.
9 IRQ5 (LPT2) [OFF]
9 IRQ6 (Floppy Disk) [OFF]
9 IRQ7 (LPT1) [OFF]
9 IRQ8 (RTC Alarm) [OFF]
9 IRQ9 (IRQ2 Redir) [OFF]
9 IRQ10 (Reserved) [OFF]
9 IRQ11 (Reserved) [OFF]
9 IRQ12 (PS/2 Mouse) [ON]
9 IRQ13 (Coprocessor) [OFF]
9 IRQ14 (Hard Disk) [OFF]
9 IRQ15 (Reserved) [OFF]
PnP/PCI Configurations
The PnP/PCI Configurations menu allows you to set the plug and play, and PCI options.
Î PNP OS Installed [No]
The PNP OS Installed option allows you to determine whether or not installing a PNP(Plug &
Play)-aware OS onto your system. If set to Yes, your OS should have the control over all devices
installed. If set to NO, your BIOS has the control instead. For integrations involving some legacy
ISA devices, it is recommended to turn it off.
Î Init Display First
This item allows to select to boot your system using the PCI graphics card (if implemented) or the
onboard graphics controller.
Î Reset Configuration Data [Disabled]
The Reset Configuration Data option allows you to reset the Extended System Configuration
Data (ESCD) when you exit setup if you have problems booting the system up after you have
installed a new add-on.
Î Disabled (D EFAULT ) ESCD will not be reconfigured
Î Enabled ESCD will be reconfigured after you exit setup
Î Resources Controlled By [Auto (ESCD)]
The Resources Controlled By option gives you the option of manually configuring all the boot
and plug and play devices, or allowing BIOS to configure these devices automatically. If you allow
BIOS to configure it automatically you will not be able to select the IRQs, DMA and memory base
address fields because BIOS will automatically assign them.
Î Auto(ESCD) (D EFAULT ) BIOS automatically configures plug and play devices as
well as boot devices.
Î Manual You manually configure the plug and play devices and
any other boot devices
Î x IRQ Resources [Press Enter]