KERN & SOHN DLB 160-3A - Manual (Page 16)

16 DLB_A-BA-e-1511
3
2. Power supply to the heating top is provided via the supplied mains cable. Do not
connect the appliance to the power grid unless the information on the appliance
(sticker) matches the local mains voltage.
To switch on, press the main switch on the rear side of the appliance.
3. Attach the connection cable balance / heating top.
The appliance must be connected to a standard socket with earth terminal. Do not
eliminate the protective effect by using an extension lead without earth terminal. For
power supplies from power grids without earth terminals call a specialist to establish
equivalent protection according to the relevant installation regulations.
6.4 Connection of peripheral devices
Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the moisture analyser from the power supply.
Only use accessories and peripheral devices by KERN, as they are ideally tuned to the
appliance.
6.5 Initial Commissioning
In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. During this warming up
time the balance must be connected to the power supply (mains, accumulator or
battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.