2 calibrate / adjust temperature – KERN & SOHN DLB 160-3A User Manual
Page 19
Advertising
DLB_A-BA-e-1511
19
8.2 Calibrate / adjust temperature
We recommend sometimes to check the temperature value of the device using the
optional temperature calibrating set DLB-A01N. Before you do this, allow the device to
cool down for at least 3 hours after the last heating phase.
Preparation:
Install the temperature-calibration set acc. to illustration.
1.
Switch-on the drying unit on the rear side.
Close heating cover.
Advertising