KERN & SOHN MPE 250K100HM - Manual (Page 47)

14 Error messages
Display
Description
Zero range exceeded
(on start-up or when pressing the key)
• Load on weighing pan
• Excess load, during zero setting of weighing scale
• Incorrect adjusting process
• Fault on load cell
Value outside the A/D converter range
• Damaged weighing cell
• Damaged electronics
Should other error messages occur, switch balance off and then on again. If the error
message remains inform manufacturer.
MPC_M / MPE_HM / MPE_PM-BA-e-1414 47