LABEC M-TIT-5 - Manual (Page 23)

Diag.31 Display for titration of end volume
NOTE: If the meter finds that 5 pcs end points have been found, it will stop titration directly no
matter whether the titration has other end points or not.
When titration finished, meter will switch off the stirrer automatically and control the feeding of
solution till end, then meter enters into viewing status, the display of whole titration curve and end
point results as follows:
Pre-titration>Titration panel PAUSE 00:04:18
End
End titration?
Enter Exit
Store Mode Concentration End point Print About
Ending volume for your
setting adding is over!
Diag.32 Displayed current titration data when titration finished.
Menu includes: ‘Store’, ‘Mode’ (if there is end point), ‘Concentration’ (if there is end point), ‘End
point’, ‘Print’, ‘About’ and ‘Switch off’ buttons. In the middle is titration curve that user can view
the titration data. On the bottom of left corner is the titration data corresponding to indicating line
22