PRG AutoPar User Manual 2.1 - Manual (Page 18)

10 AUTOPAR ® WASH LUMINAIRE USER MANUAL
Male Termination Connector
A male XLR termination connector is required at the last luminaire (or "far end of the line")
to prevent signal reflections. Signal reflections may cancel out the signal at certain line
lengths, resulting in errors. The terminator is also necessary for software downloads and
running tests on multiple luminaires.
To construct your own connector, you will need the
following components:
+ 5-pin, male XLR connector.
+ Two 1/4W 5% 120 ohm resistors.
Note: A male termination connector is also available as an accessory from PRG. See "Replacement Items and
Accessories" on page 5.
Solder resistors across
pins 2 & 3, and 4 & 5
1
2
3
4
5