Programming a starting address, Programming starting address without calibrating, Configuring lamp operation and other options – PRG AutoPar User Manual 2.1 User Manual
Page 23
AUTOPAR
®
WASH LUMINAIRE USER MANUAL
15
Programming a Starting Address
The address setting for DMX512 systems is programmed at the Menu Display (refer to
on page 18 for
more detailed instructions). The luminaire retains its DMX512 address even if power is removed.
Note: Refer to your console operating instructions for specific information regarding its addressing requirements.
Program a DMX512 starting address:
Step
1. Press [Enter] to access top level functions.
Step
2. Press [Up] / [Down] arrows to scroll to
Dmx
menu. Press [Enter].
Step
3. Press [Up] / [Down] arrows to scroll to
Address
menu. Press [Enter] to begin edit mode.
Step
4. Press [Up] / [Down] arrows to enter starting address.
Step
5. Press [Enter] to set.
Figure 2-6: Setting DMX512 Address
Programming Starting Address Without Calibrating
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in order to pre-
program an address setting.
Program starting address without calibrating luminaire:
+
While powering up luminaire, press and hold [Menu]. Program address as in
Programming a Starting Address
above.
Note: The luminaire will require a reset to restore control.
Configuring Lamp Operation and Other Options
The lamp can be turned off or on using the Menu Display. The luminaire can also be configured to power up with the
lamp on or off. For instructions on setting all menu options, refer to
MENU ENTER
No Comm
Menu Display
Address
30
Luminaire Status
Setting DMX512 Address
Dmx