Power up procedure, Powering up the luminaire – PRG AutoPar User Manual 2.1 User Manual
Page 22
14
AUTOPAR
®
WASH LUMINAIRE USER MANUAL
POWER UP PROCEDURE
Powering Up the Luminaire
When AC power is applied, the luminaire will begin a calibration sequence which moves its pan, tilt, and lens rotation
mechanisms. After calibration, the luminaire head will either stop at its "home" position (which positions the pan axis
at mid-rotation and the head parallel to the yoke with the lens pointing away from the luminaire upper enclosure) or
move to its current DMX-defined position if DMX512 data is present. The lens rotation mechanism will also move to its
"home" or DMX-defined position.
The lamp is set to off in the default mode. DMX512 control is required to strike the lamp.
CAUTION:
Before applying power, be sure the luminaire is hung or positioned so that the head and yoke
can move freely without restriction.
CAUTION:
If luminaire is operated without yoke leg covers in place, pan problems will occur.
To power up:
Step
1. At each luminaire, connect AC input cable and apply power. Allow luminaire to complete its calibration
sequence.
Step
2. For normal power up, Display Menu will display "Status OK." After a few seconds, Menu will display a DMX
address or "No Comm" if an address has not been set or no DMX512 signal is detected.
Step
3. To strike lamp, send appropriate DMX512 value from console. Refer to
Figure 2-5: Menu Display at Power Up
Note: Refer to
on page 18 for more information about the Menu Display.
MENU ENTER
Status
OK
Menu Display
DMX
1
No Comm
OR
Luminaire Status
DMX512 Signal