Solvline Eddy Serial v2.5.1.1 - Manual (Page 43)

Eddy User's Guide
43
Menu Default Descriptions
For example, if the operation mode is set to TCP Server and Alive Check
Time is configured to 10, TCP Server will listen for the client’s
connection and eventually establish a connection. Since the check time
is 10 seconds, the server will wait for 10 seconds until the client
connected to it sends any packet. If there is no data for 10 seconds,
server will quit the connection and return to the listening state. This
option is helpful in preventing communication obstacles that occur when
either Eddy or the client quits unexpectedly (i.e. Sudden black out,
reboot, LAN cable cut, etc.). In these cases, the other part of
communication might not recognize the failure of its partner. Such
misunderstanding can cause communication errors.
If the value is set to 0, this function is disabled. Once connected socket
will be retained until explicitly disconnected.
(Only applies to TCP Client, TCP Server, TCP Broadcast, and TCP
Multiplex operation modes.)
Latency
Time
0
This needs to be set when consecutive data from the given serial port
needs to be transmitted to socket at once.
For example, if 100 bytes of character string are to be transmitted from
the serial device to a server through Eddy, bypass is set to 0 for the
latency time. Although it provides immediate sending through Eddy, the
server could be received a lot parts of divided packets.
If the latency time is not 0, Eddy will wait for the time and check new
data. If there is new data, Eddy repeatedly wait for the time. Otherwise,
Eddy will transfer the buffered data, but it could not run in real time.
Port Login Disable
When the Operation Mode is set to TCP Server, ask for the username
and password when the client tries to connect
(Options: Enable, Disable)
Passive
Username
eddy
When the Operation Mode is set to TCP Server, set the username to ask
for. 16 Characters at maximum.
Passive
Password
99999999
When the Operation Mode is set as TCP Server, set the password to ask
for. 16 Characters at maximum.
5.5 Wireless Settings
You can set the wireless network parameters. After changing values, you need to click [Submit] button. Then you will
see the same page with modified values. Please note that you have to [Save & Reboot] in order to see these changes
in effect. Changes will be discarded if you do not save current settings.