Solvline Eddy Serial v2.5.1.1 - Manual (Page 66)

Eddy User's Guide
66
+++
OK
ATD000195000004
CONNECT000195000004
+++ AT+BTMODE,1
After
rebooted automatically
master tries to connect to slaves
After input the BD addresses of the slave units into 4 S-registers S46, S54, S55 and S56 and then set operation
mode as MODE1, users can use multiple connection function. If S-registers have available slaves’ address, AUTO
CONNECT message will be displayed following corresponding TASK.
AT+MULTI,n
Select a multiple connection mode
AT+MLIST?
It shows the current mode, the connection status and the BD addresses of slaves.
ATHx, ATHbdaddr
Using the ATH command, connections with all slaves or only connections with specific slaves can be disconnected
selectively
ATH Disconnect all the slaves.
ATHx (ATH1, ATH2, ATH3, ATH4) Disconnect the slave which belongs to the TASK x.
ATHbdaddr (ATH000195000001) Disconnect the slave with specified BD address.
TASK1 OK – AUTO CONNECT
TASK2 OK
TASK3 OK – AUTO CONNECT
TASK4 OK
at+mlist?
CURRENT MODE: MULTI DROP
TASK1 – 000195000001
TASK2 – 000195000002
TASK3 – DISCONNECT
TASK4 - 000195000004
OK