Solvline Eddy Serial v2.5.1.1 - Manual (Page 81)

Eddy User's Guide
81
to Standby. Since the Eddy-BT skips the process of detecting escape sequence characters, more efficient data
transmission can be had.
S11=1, Eddy-BT allows for the escape sequence character. Whenever it is needed, the Connect status can be
changed to Standby.
S12: Clear Data Buffer When Disconnected (default 0)
S12=0, Eddy-BT does not clear the data buffer received from host system when disconnected.
S12=1, Eddy-BT clears the data buffer when disconnected.
S13: Enable DCD Signal (default 1)
S13=0, DCD signal off
S13=1, DCD signal on
S14: Enable DTR Transfer (default 1
S14=0, DTR/DSR signal is transferred in a loop-back fashion..
S14=1, DTR signal is transferred to DSR of remote device.
S15: Enable Disconnect by DTR (default 0)
S15=0, DTR signal cannot release the connection.
S15=1, The Bluetooth connection can be released when DTR signal is off.
This value decides whether Bluetooth connection is released when DTR signal drops or not. If this value is 1, you can
use DTR signal in order to disconnect Bluetooth connection.
S22: Faster Connection (default 3)
S22=0, none
S22=1, page scan
S22=2, inquiry scan
S22=3, page/inquiry scan
Connecting time is average 1.5sec faster than normal mode.
S23: Intercharacter Timeout Setting (default 0)
S23=0 : Not used
S23=1 : 1 x S26
S23=2 : 10 x S26
S23=3 : 100 x S26
S24: Maximum Number of Inquiry Result (default 15)
The maximum number of inquiry list can be controlled. This value is up to 15.