Combi 8045 - Manual (Page 13)

23
Place base rear-facing in the vehicle seat location selected with blue lap belt guides
toward vehicle seat back and centered between the vehicle lower anchors (fig. d).
Attach car seat to base.
Adjust recline using recline indicator on the side of the car seat. Line of recline
indicator MUST be in green striped zone (fig. e). If line is not in green striped
zone, adjust base using recline foot (see “Base Adjustment” section), and recheck
recline of car seat. Repeat until recline indicator is in green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. If necessary, place tightly rolled towel, pool noodle, or firm object
under recline foot to level car seat.
2. Try a different seating position.
3. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface
during this installation.
Remove car seat from base.
8
9
(fig. d)
10
(fig. e)
Recline
Indicator
Green
Striped Zone
Connect lower anchor connectors to vehicle lower anchors:
- With hook-on connector opening facing down , position the opening of the
connector over the vehicle lower anchorage. Push down and then pull out
on the connector to lock it onto the vehicle anchorage (fig. f). You should hear
a click.
- Pull on connector to be sure it is locked onto the anchorage.
- Repeat for connector on opposite side.
Tighten lower anchorage belt to secure the base. Press down
in center of base to depress the vehicle cushion and pull free
end of lower anchor belt to tighten belt around base (fig. g).
Check for secure installation. Pull base front to back and left
to right to check for secure installation (fig. h). LATCH belt
MUST stay tight.
If LATCH belt does not stay tight or base can not be securely
installed, try a different LATCH location or use the vehicle’s
seat belt to secure
the base.
24
(fig. f)
(fig. h)
11
12
(fig. g)
1
2 3
1
2
3