Combi 8045 - Manual (Page 20)

37
Section 11 - Operation and Adjustment
Harness Use and Adjustment
Harness Strap Adjustment:
• To tighten: Pull front adjuster strap (fig. a).
• To loosen: Insert finger under adjuster cover on pad,
press harness adjuster lever, and pull harness straps
out.
• If the harness cannot be adjusted to properly fit
child, (see “Changing Harness Length And Use
Position” section).
Chest Clip Operation:
• To open: Press tabs and pull apart (fig. b).
• To close: Snap halves together. Make sure chest clip is locked
by pulling out.
(fig. a)
(fig. b)
1
1
2 2 1 2
Harness
Adjuster
Strap
Harness
Adjuster
Lever
(Under
Adjuster
Cover)
Changing Use Position and Harness Length
Each shoulder harness strap has two harness adjustment loops,
and , to adjust harness fit as the infant grows. 38 (fig. a)
Shoulder
Harness
Loops
1
2
1 2
WARNING
• Shoulder belts MUST be through belt slots in infant insert.
• Shoulder harness MUST snugly adjust around infant.
• Shoulder harness straps MUST be through slots at or just
below shoulders.
Shoulder Strap Covers: Either “Folding” or “Tube” style covers are provided
Folding Style Covers:
Open folded shoulder strap cover, place over shoulder belt above chest clip
with folded side toward child, and close shoulder belt cover (fig c.)
Tube Style Covers:
Unhook harness and pull out through seat back, see “Changing Shoulder
Harness Slot Position” section. Slide shoulder belt up through strap cover,
rethread harness straps through seat back, and re-attach harness to metal
harness plate. (fig. c)