Combi 8045 - Manual (Page 22)

41
Carry Handle Operation - Carry handle has four positions (fig. c):
A. Vehicle use position and carrying position
B. Rocking position
C. Rocking position
D. Reclined seat position
Each handle position can be used for vehicle positions
depending on size of vehicle.
To change carrying handle position:
• Push in handle adjustment buttons on each side of handle (fig. d).
• Rotate handle forward or backward until it locks into a use position.
IMPORTANT: Check to be sure carry handle is locked before lifting car seat.
NOTE: Handle does not lock between position C and position B. Handle will move from position C into position
B without pushing in handle adjustment buttons.
(fig. c)
A
B
C
D
(fig. d)
1
2
Handle
Adjustment
Button
1
1
2
Base Adjustment:
The base has a three position adjustable recline foot to assist in properly reclining the car seat.
Use recline indicator to verify proper car seat recline position.
To Adjust:
- Pull out on recline adjustment handle and lower or
raise recline foot to desired position (fig. a).
- Release recline adjustment handle to lock recline foot in position.
42
(fig. a)
• Rear-facing car seat MUST be properly reclined:
- Too reclined can result in injury or death from ejection.
- Too upright can result in breathing difficulties.
WARNING
DEATH or SERIOUS INJURY can occur
Recline
Adjustment
Handle
1
2
3