Combi 8045 - Manual (Page 18)

Check for secure installation. Pull front to back and left to right to check for secure
installation (fig. d). Vehicle lap belt MUST stay tight.
If vehicle lap belt does not stay tight, see “Installation with Lap/Shoulder Belts” below.
Recheck car seat recline. Verify line is in green striped zone of recline indicator.
Carry handle should be kept in the carry position, (see “Carry Handle Operation”
section).
33
8
9
7
(fig. d)
Installation with Lap And Shoulder Belts:
• When using vehicle lap and shoulder belts, shoulder belt may
be used for additional support. Place shoulder belt around
back of Combi Connection™ (fig. e) and through the vehicle
shoulder belt guide on back of car seat shell (fig. f). If
shoulder belt is too short to go around back of Combi
Connection™, position shoulder belt against vehicle seat
back (fig. g). Do not route shoulder belt through lap belt
guides on either side of car seat.
• Lap/shoulder belt with free sliding latch plate:
- Pull out on latch plate (fig. h). If belt slides freely
through latch plate, a locking clip must be used as
described in “Locking Clip” section.
- Some combination lap/shoulder belts with free sliding
latch plates may be converted into an “automatic
locking mode” that will allow use without a locking clip.
See vehicle owner’s manual and label on vehicle belts
for instructions.
34
(fig. e) (fig. f)
(fig. g) (fig. h)
Shoulder
Belt Guide