Combi 8045 - Manual (Page 16)

29
Position vehicle lap belt on vehicle seat.
a. Extend vehicle lap belt all the out the way out and buckle vehicle belt.
b. Place center section of lap belt flat on vehicle seat as shown in fig. c.
Check that vehicle lap belt is not twisted and lays flat across seat.
Route vehicle lap belt through base.
a. Center base on the center section of lap belt.
b. On side of base lift lap belt up and hook over blue belt guide , placing
lap belt into belt slot on blue belt guide (fig. d). Check that lap belt is
not twisted.
c. Repeat step b for opposite side of base.
NOTE: When installing with a lap and shoulder belt, route
only the lap belt through the base, DO NOT route
the shoulder belt through base.
(fig. c)
6
1
2
(fig. d)
1
2
7
Center Section
Of Lap Belt
30
Tighten vehicle belt to secure the base. Press down in
center of base to depress the vehicle cushion while
tightening vehicle belt (fig. e & f).
- When using a vehicle lap and shoulder belt, after
tightening lap portion of the belt, place shoulder belt
into slot in corner of base and allow shoulder belt to
rest against vehicle seat back (fig. g).
Check for secure installation. Pull base front to back and
left to right to check for secure installation (fig. h). Vehicle
lap belt MUST stay tight.
If the vehicle lap belt does not stay tight or base cannot be
securely installed, see vehicle owner’s manual, “Vehicle
Seat Belts” section or move to a different seating location.
Attach car seat to base. Lift car seat to ensure it is properly
attached to the base (see “Attachment Of Car Seat To
Base” section).
Recheck recline of car seat. Adjust if necessary
(see step 4).
12
11
10
(fig. h)
(fig. f) (fig. e) Lap Belt Lap and
Shoulder Belt
8
9
(fig. g)