Combi 8045 - Manual (Page 21)

Changing Shoulder Harness Length:
1. Buckle harness and chest clip.
2. From front of car seat, unsnap harness adjuster strap from
front of car seat pad, loosen harness straps by pressing
harness adjuster lever,
, and pulling harness straps out,
(fig. d).
3. From back of car seat, remove both harness adjustment
loops from metal harness plate (fig. e).
4. Route shoulder harness straps between plastic
seat and metal rod.
To lengthen shoulder harness:
- Re-attach metal harness plate
in lower adjustment loops
on shoulder harness straps (fig. f).
To shorten shoulder harness:
- Re-attach metal harness plate
in upper adjustment loops
on shoulder harness straps.
5. Check that loops are completely in slots
of metal harness plate, and under tabs
on both sides (fig. f).
3
4
39
(fig. d)
Shoulder
Harness
Adjuster
(Under
Adjuster
Cover )
4
3
(fig. e)
Shoulder
Harness
Loop
Metal
Harness Plate
(fig. f) Tab
2
1
2
1
Metal
Rod
Changing Shoulder Harness Slot Position:
1. Buckle harness and chest clip.
2. Loosen harness straps, (see “Harness Use And Adjustment” section).
3. From back of car seat unhook both harness loops from
metal harness plate (fig. b).
4. From front of car seat, pull harness straps out through infant
insert, seat pad, and car seat shell.
5. From front of car seat, rethread harness straps through infant
insert (for use with lower slots on seat back only), desired
harness strap slots of seat pad, and seat back.
Make sure harness straps are not twisted
and are threaded through matching slot of
infant insert, seat pad and seat back.
6. From back of car seat, route shoulder harness
straps between plastic seat and metal rod,
then re-attach harness adjustment loops to
metal harness plate (fig. c).
Check that loops are completely in slots
of metal harness plate and under tabs
on both sides.
40
Metal
Harness Plate
(fig. c)
Tab
Shoulder
Harness
Loops
(fig. b)
Metal
Harness Plate
Metal
Rod