Combi 8045 - Manual (Page 23)

43
Mommy’s Lap Infant Insert:
WARNING
• To prevent ejection:
- Shoulder belts MUST be through belt slots in infant insert.
- For proper harness fit, infant insert MUST be used for small infants.
• Discontinue use of the infant insert when:
- Harness is through top shoulder belt slots on car seat.
- Shoulder belts become too short to fit infant.
To Assemble Infant Insert:
1. Unhook harness straps, see “Changing Shoulder Harness Slot Position” steps 1 - 4.
2. Unbuckle harness and chest clip.
3. Place infant insert in car seat.
44
4. Thread shoulder harness belts and crotch belt with buckle up
through slots in infant insert, rethread harness straps through
infant insert and lower harness strap slots of seat back.
5. From back of car seat, route shoulder straps between plastic seat and
metal rod, then re-attach harness adjustment loops to metal harness
plate, (see “Changing Shoulder Harness Slot Position” section).
6. Route strap at top of infant insert over top of seat back and snap to
seat pad.
Reverse above steps to remove infant insert.
Head Pillow:
Use of head pillow is not required
To Attach:
1. Thread strap on head pillow up through desired slot in top of infant
insert and snap strap on head pillow to strap on infant insert.
To Remove:
1. Unsnap strap on head pillow from strap on infant insert and slide
head pillow down to pull strap out of infant insert.
Infant Insert
Pillow
Infant Insert
Infant Insert