Combi 8045 - Manual (Page 17)

Installation with Lap Belt Only:
Refer to vehicle owner’s manual to identify the seating locations which can be used
with a car seat. Check for specific instructions for car seat use.
After selecting a seating location, if vehicle seat back is adjustable, adjust vehicle seat
back into most upright position.
Place car seat rear-facing on vehicle seat.
Thread vehicle lap belt through vehicle lap belt guides on car seat (fig. a) and buckle
vehicle belt. Be sure vehicle lap belt is not twisted.
31
4
Securing Infant Car Seat Without Base:
• Not all vehicle seat belts can be used with a car seat. Read vehicle owner’s manual and
“Vehicle Seat Belts” section in this manual.
WARNING
DEATH or SERIOUS INJURY can occur
1
2
3
(fig. a)
32
Press down firmly on car seat to compress vehicle seat
cushion while tightening vehicle lap belt (fig. b).
Adjust recline using the recline indicator on the side of
car seat (fig. c). Line on recline indicator must be in green
striped zone.
If line is not in green striped zone, place a tightly rolled up
towel, blanket or firm foam (pool noodle) under end of car
seat contacting vehicle seat back.
If car seat can not be adjusted to locate the line in the green
striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface
during this installation.
6
(fig. c)
Recline
Indicator
Green Striped
Zone
(fig. b)
5