Combi 8045 - Manual (Page 15)

27
Securing Base With Vehicle Seat Belt:
• Not all vehicle seat belts can be used with a car seat. Read vehicle owner’s manual and
“Vehicle Seat Belts” section in this manual.
WARNING
DEATH or SERIOUS INJURY can occur
Refer to vehicle owner’s manual to identify the seating locations which can be used
with a car seat. Check for specific instructions for car seat use.
After selecting a seating location, if vehicle seat back is adjustable, adjust vehicle
seat back into most upright position.
Place base with car seat attached rear-facing on vehicle seat with blue lap belt
guides toward vehicle seat back (fig. a).
1
(fig. a)
2
3
Adjust recline of car seat. Line inside recline indicator on side of car seat MUST
be in green striped zone (fig. b). If line is not in green striped zone, adjust base
(see “Base Adjustment” section), and recheck recline of car seat. Repeat until
recline indicator is in the green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. If necessary, place tightly rolled towel, pool noodle, or firm object
under recline foot to level car seat.
2. Try a different seating position.
3. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface
during this installation.
Remove car seat from base.
4
5
28
(fig. b)
Recline
Indicator
Green
Striped Zone