USL JSD-60 Manual - Manual (Page 19)

Page 19

The Microphone Library holds calibration data on microphones used on the RTA. A separate file can be
created for each microphone used with the system. The file includes the required preamp gain and
frequency response adjustment.

The Speaker Library holds crossover configuration files for a wide range of biamp speaker systems. These
are also text files, so appropriate crossover settings for additional speaker systems can be created using a
text editor such as Note Pad.
See Appendix E for configuration file formats.
8.2
GUI Installation
The GUI runs under Windows® XP, Windows® 7, or Windows® 8 operating systems. Insert the supplied CD and
follow the on-screen instructions.
Note: The USB driver needs to be installed after the GUI is installed. Follow the USB Driver Installation
instructions.
Note: Windows XP installs a driver for a particular USB port and when connected to a different port, the user must
repeat the installation process. We suggest executing the install process on all USB ports.
USB Driver Installation
The JSD-60 uses a native Windows USB System (winusb.sys) driver that is part of the operating system’s installation
package. The driver is installed by using a co-installer that specifies that it will be working with the JSD-60.
Installation with Windows 8, requires setting the start up to run with “Driver Signature Enforcement Disabled.” The
JSD-60 Installation (Setup) program creates a subfolder called “WinUSB_Drivers” that will be used for loading the
new WinUSB driver. This folder contains two subfolder “x86” and “amd64” with the driver version for the
operating system type 32 and 64 bit.
Windows 7 USB Driver Installation
Located in the WinUSB_Drivers folder in the installation disk or in the installed program files(x86) folder, there are
two version of DPInst32 and DPInst64 utilities.

For Windows 7 64bit, use the “Start” button to open “All Programs” and navigate to USL\JSD-60 Cinema
Processor and run DPInst64.exe. For Windows 7 32bit, use File Explorer to open “C:Program Files\USL\JSD-
60\WindUSB_Drivers” and run DPInst32.exe.

An installation dialog window will appear. Activate “Next” to proceed.

A warning message box will appear. Select the “continue the installation” anyway option.

The installation dialog will indicate an installation status, and a final close button will appear. If the installation
fails, use device manager as described in the Windows XP installation section.
Windows 8 USB Driver Installation
To install the JSD-60 USB driver, the start up settings must be changed to disable driver signature enforcement.
After doing this, the installation of the driver will the same as for Windows XP and 7.
Windows 8 Disable Driver Signature Enforcement:

Activate the Charms menu by moving the mouse to the lower right corner of the screen. In the Charms menu
activate “Settings.”

In the “Change PC Settings” group, select Power. A pop-up options menu appears. Hold the shift key and then
activate the “Restart” option on the pop-up menu.

The “Choose an Option” screen will appear. Select the “Troubleshoot” option.