USL JSD-60 Manual User Manual
Page 48
Page 48
RJ-45 AES/EBU Input
The JSD-60 uses the StudioHub pin out for AES/EBU over CAT5 or CAT6
Ethernet cable. These cables are twisted pair and have the required
characteristic impedance.
Signals Listed By Channels
Audio Channels
AES/EBU
Pair
RJ-45 Pins ( +, - )
Speakers
1, 2
1
1, 2
L, R
3, 4
2
3, 6
C, LFE
5, 6
3
4, 5
Ls, Rs
7, 8
4
7, 8
(Lc/Rc),
(Lrs/Rrs),
(HI/VN)
Signals Listed By Connector Pins
RJ-45
AES/EBU Signal
Name
Channel Name
1
1/2+
Left/Right+
2
1/2-
Left/Right-
3
3/4+
Center/LFE+
4
5/6+
Left Surround/Right Surround+
5
5/6-
Left Surround/Right Surround-
6
3/4-
Center/LFE-
7
7/8+
Lc/Rc+ , Lrs/Rrs+ , HI/VI-N+
8
7/8-
Lc/Rc- , Lrs/Rrs- , HI/VI-N-
Six Channel Analog Input
The JSD-60 six channel analog input is on a DB25F connector. The analog inputs are active balanced (differential)
inputs. They may be driven by balanced or unbalanced sources. When driven by an unbalanced source, the
negative input should be connected to the low side of the source at the source equipment to minimize ground
loop noise. The cable should be twisted pair with individual shields, even when driven by an unbalanced source.
The DB25F connector uses the THX® pin out as specified in the table below.
Signals Listed By Channels
Channel Number DB25F PINS ( +, -, shield ) Speakers
1
2, 14, 1
Left
2
8, 20, 7
Right
3
5, 17, 4
Center
4
25, 12, 13
LFE
5
23, 10, 22
Ls
6
24, 11, 9
Rs