USL JSD-60 Manual - Manual (Page 25)

Page 25
The drive in channel configuration setting is used for outdoor theaters that are equipped with a stereo FM
transmitter and field speakers for in-vehicle listening. Additional outputs are for the snack bar speakers and
monitor. In this configuration, the main fader only controls the snack bar outputs. All other outputs (transmitter,
field speaker, etc.) remain at the levels set by the corresponding output trim controls.
Output
Channel
Number
Output Channel Name Main Fader Control
1 Left Transmitter Bypassed
2 Right Transmitter Bypassed
3 Not used
4 Not used
5 Field Speakers (Mono) Bypassed
6 Snack Bar (Mono) Enabled
7 Monitor (Mono) Bypassed
8 Not used
9 Hearing Impaired Bypassed
10 Visually Impaired/Voice
Narrative Bypassed
5.1 Channel Configuration
When configured for 5.1, JSD-60 outputs 7 and 8 are not used. The first six channels of the AES/EBU input carry 5.1
audio from the digital cinema server. AES/EBU channel 7 may be used to drive the HI output. AES/EBU channel 8
may be used to drive the VI-N output. The exact channel mapping is set on the Advanced tab.
5.1 Biamp Channel Configuration
This channel configuration option only appears when the JSD-60 is configured with a crossover output board. This
interface board routes the left, center, and right high bands to an additional output connector. When 5.1 biamp
configuration is selected, the crossover controls in the crossover tab are enabled. The HI and VI-N source can be
configured for AES/EBU channels 7 and 8.
7.1SDDS Channel Configuration
The 8 channel sources for AES/EBU map directly to the 8 outputs, left, left center, center, LFE, right center, right,
left surround, and right surround. The sources for HI and VI-N are configurable via the channel mixer available in
the advance tab. The JSD-60 can generate HI. VI-N is not available.
7.1DS Channel Configuration
The 8 channel sources for AES/EBU map directly to the 8 outputs, left, right, center, LFE, left surround, right
surround, left rear surround, right rear surround. The sources for HI and VI-N are configurable via the channel
mixer available in the advance tab. The JSD-60 can generate HI. VI-N is not available.
7.1DS Biamp Channel Configuration
This channel configuration option only appears when the JSD-60 is configured with a crossover output board. This
interface board routes the left, center, and right high bands to an additional output connector. When 7.1 DS biamp
configuration is selected, the crossover controls in the crossover tab are enabled. The 8 channel sources for
AES/EBU map directly to the 8 outputs, left, right, center, LFE, left surround, right surround, left rear surround,
right rear surround. The JSD-60 can generate HI. VI-N is not available.