VACUUBRAND MZ 2C VARIO - Manual (Page 13)

page 13 of 51
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 999034 / 22/04/2008
General view display
The controller can be adapted to the specific application by choosing another mode
than ”Vacuum control” (factory-set), see section ”General view modes”.
The status of the controller respectively of the connected accessories is displayed by
corresponding symbols on the LCD. After switching on the version of the software is
displayed, than the mode as well as the symbols “coolant valve” and “venting valve”, if
the valves are preselected.
automatic mode
Pressure reading
selectable
pressure units
process control
active
warning (in combination with
other symbols)
modes coolant valve pump symbol time
counter
venting valve
remote operation
mode vacuum control or
continuous pumping
mode VACUU•LAN
Description