VACUUBRAND MV 2 NT VARIO - Manual (Page 86)

page 86 of 106
Tools required (metric):
- 5 mm wide Allen key
- Diaphragm key width 66 mm
Service kit for MD 4 NT VARIO / MV 2 NT VARIO ......................................696861
Service kit for MV 10 VARIO-B ....................................................................696827
Diaphragm key (width 66 mm) ...................................................................636554
Ensure that maintenance is done only by suitably
trained and supervised technicians.
The valves and diaphragms are wear parts. If the rated
ultimate vacuum is no longer achieved or in case of in-
creased noise level, the pump interior, the diaphragms
and the valves must be cleaned and the diaphragms and
valves must be checked for cracks or other damage.
All bearings are encapsulated and are filled with long-life
lubricant. Under normal operating conditions, the drive
system is maintenance free.
In demanding circumstances, it may be efficient to check
and clean the pump heads on a regular basis. In normal
use, the lifetime of the diaphragms and valves is typically
15,000 operating hours.
- Prevent internal condensation, transfer of liquids or
dust. The diaphragms and valves will be damaged if
liquid is pumped in significant amount.
- Carry out maintenance frequently if the pump is ex-
posed to corrosive media or in case of deposits.
- Regular maintenance will improve the lifetime of the
pump and also protect both users and the environment.
NOTICE
Cleaning and inspecting the pump heads
(MD 4 NT VARIO / MV 2 NT VARIO)