Wilson Audio WATCH Center Channel Series 1 - Manual (Page 47)

47
Note: Before setting up the WATCH Center Channel study carefully the previ-
ous sections on room acoustics and initial setup information. They provide
valuable information on determining the ideal room locations for your speak-
ers.
S e c t i o n 4 - W A T C H C e n t e r C h a n n e l S e t u p
You will need the following items:
• Supplied hardware kit
• Tape measure
• Known listening position
Note: The WATCH Center Channel is shipped with four set screws, which are
inserted into the threaded holes on the bottom of the Center Channel. If you
are simply placing the Center Channel on a shelf and are not planning on fol-
lowing the setup procedure, leave these set screws in place. If you are planning
on mounting the Center Channel to a stand or using any provided spikes to
angle the Center Channel towards the listening position, these four set screws
will need to be removed. Remove the set screws as follows:
1. Carefully set the speaker onto its side.
2. Using the provided 3/16” angled Allen wrench, unscrew the set screws.
Note: You should have two 1 1/2” set screws and two 2” set screws. Save these
set screws as you will need them if you plan on adding rotation towards the
listening position.
3. Proceed to the installation instructions provided.
S
E C T I O N
4 - WAT C H C
E N T E R
C
H A N N E L
S
E T U P