Wilson Audio WATCH Center Channel Series 1 - Manual (Page 64)

64
3. Lay the Center Channel on its side and screw the four 3-inch setscrews
one inch into the threaded holes on the bottom of the speaker.
Note: Be sure that the Allen key end of the setscrews is facing out when
screwing it into the enclosure. This will allow for easy installation and
removal in the future.
4. Using the 5/32” T-handled Allen wrench, remove the two midrange driv-
ers. Do not unsolder the leads (see Figure 13).
Note: The material used for the bottom of the Center channel is a high densi-
ty composite. This material is easily cross threaded when installing the
setscrew. Be careful that the spike thread is engaging properly into the bot-
tom.
5. Screw on the 3/8”-16 nut and lockwasher onto the setscrew from the
inside of the enclosure (see Figure 14).
6. Tighten until snug using the open ended wrench.
7. Replace the midrange drivers.
8. While two people hold the speaker up to the mounting bracket, a third
person bolts the speaker to the ceiling. Use two 3/8”-16 nuts on each
threaded road. This will lock the nuts into place.
Note: The custom mounting bracket should be designed to hold three times
the weight of the Center Channel (250 lbs). This gives an acceptable safety fac-
tor of three.
9. Turn to Section 4.6 for final assembly instructions.
WAT C H C
E N T E R
C
H A N N E L
O
W N E R
’
S
M
A N U A L