Wilson Audio WATCH Center Channel Series 1 - Manual (Page 54)

54
1. Using provided 3/16” Allen wrench, remove the 4 setscrews from the bot-
tom of the Center channel. Keep these as they are the setscrews needed
to assemble your spikes.
2. Turn to Section 9, page 107. Locate your listening position on the table.
3. Assemble the front spikes with the listed diode/spacer combination.
4. Install the spikes as shown in Figure 8 above.
Note: The material used for the bottom of the WATCH Center channel is a
high density composite. This material is easily cross-threaded when installing
the spikes. Be careful that the spike thread is engaging properly into the bot-
tom of the enclosure.
5. Carefully lift the Center channel into the desired location and set it
down.
Note: Four small brass disks have been provided for use as spike pads. Place
these under the spikes to protect the finish of your floors.
6. Turn to section 4.6 for final assembly instructions.
S e c t i o n 4 . 3 - C e n t e r C h a n n e l o n S t a n d
1. Set the stands in the desired listening location.
2. Attach the spikes to the bottom of the stand by screwing in the spike and
nut combination until the nut is flush with the bottom (see Figure 9).
WAT C H C
E N T E R
C
H A N N E L
O
W N E R
’
S
M
A N U A L