Wilson Audio WATCH Center Channel Series 1 - Manual (Page 70)

70
angled bends in the cable. If you need to turn corners, attempt to use a
gradual curve as opposed to a severe right-angled bend.
3. Connect the negative (normally black) end of the speaker cable to the
high current speaker binding post with the engraved “-” above it ( see
Figure 19).
Note: Do not over tighten the binding posts. Over tightening can cause the
posts to break off.
4. Connect the positive (normally red) end of the speaker cable to the high
current speaker binding post with the engraved “+” above it.
5. Plug your amplifier(s) AC power cord into the wall outlet.
Note: Always attempt to keep your pair of speaker cables the same length.
This will ensure that the signals arrive at each speaker in the proper time
frame, by traveling the same distance to each speaker.
C e n t e r C h a n n e l S e t u p C o m p l e t e d
This completes the initial setup of your WATCH Center channel. Final sys-
tem tuning and voicing should be performed as outlined in Section 5. Section 5 will
evaluate your entire speaker setup and allow you to make small modifications in
speaker rotation and location that will greatly improve the performance of your
multi-channel audio or home theater system.
WAT C H C
E N T E R
C
H A N N E L
O
W N E R
’
S
M
A N U A L