Front seats, Manual seat adjustment, Lumbar support – Ram Trucks 2015 ProMaster City - User Guide User Manual

Page 23

Advertising
background image

FRONT SEATS

Manual Seat Adjustment

Forward/Rearward

Lift up on the adjusting bar located at the
front of the seat near the floor and release
it when the seat is at the desired position.
Then, using body pressure, move forward
and backward on the seat to be sure that
the seat adjusters have latched.

Recliner
• To recline the seatback, lean back,

rotate the knob rearward to position
the seatback as desired.

• To return the seatback to its normal

upright position, lean forward, rotate
the knob forward until the seatback is
in the upright position.

Height Adjustment
• Ratchet the front lever, located on the

outboard side of the seat, upward to
raise the seat height.

• Ratchet the lever downward to lower the seat height.

WARNING!

• Adjusting a seat while the vehicle is moving is dangerous. The sudden

movement of the seat could cause you to lose control. The seat belt might not
be properly adjusted, and you could be severely injured or killed. Only adjust a
seat while the vehicle is parked.

• Do not ride with the seatback reclined so that the seat belt is no longer resting

against your chest. In a collision, you could slide under the seat belt and be
severely injured or killed. Use the recliner only when the vehicle is parked.

Lumbar Support

The lumbar control knob is located on the rear upper outboard side of the driver’s
seatback.
• Rotate the control forward to increase and rearward to decrease the desired

amount of lumbar support.

Manual Seat Levers

1 — Adjusting Bar

2 — Height Adjustment

3 — Recliner Knob

G E T T I N G S T A R T E D

21

Advertising