Ram Trucks 2015 ProMaster City - User Guide - Manual (Page 93)

OPENING THE HOOD
To open the hood, two levers must be released:
1. Pull the hood release lever located
under the driver side of the instru-
ment panel.
2. Move to the front of the vehicle.
3. Reach under the center front edge of
the hood and push up and hold the
safety latch lever.
4. Lift the hood upward to the open po-
sition and place the prop rod in the
receptacle location on the underbody
of the hood.
NOTE:
Properly place the hood prop rod in the
retaining clip when closing the hood or
damage to the vehicle may occur.
WARNING!
Be sure the hood is fully latched before driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is in motion and block your vision. Failure
to follow this warning could result in serious injury or death.
Release Lever
Safety Latch Lever Location
M A I N T A I N I N G Y O U R V E H I C L E
91