Electrode setting, Turbulator setting, Oil line connections – Sears Riello F10 User Manual
Page 10: Electrode setting turbulator setting
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ELECTRODE SETTING
TURBULATOR SETTING
A) Loosen NUT (1), then turn SCREW
(2) until the INDEX MARKER (3) is
aligned with the correct index number
as per the Burner Set-up chart, on
page 12.
B) Retighten the RETAINING NUT (1).
NOTE: Zero and five are scale indica
tors only. From left to right, the first line
is 5 and the last line 0.
OIL LINE CONNECTIONS
This burner is shipped with the oil pump set to operate on a
single line system.
To operate on a
two line system the by-pass plug must be installed.
Warning: Do not operate a single line system with the by-pass plug installed.
Operating a
single line system with the by-pass plug installed will result in damage
to the pump shaft seal.
Note: Pump pressure must be set at time of burner start-up. A pressure gauge is
attached
to
the
PRESSURE
PORT
(8)
for
pressure
readings.
Two
PIPE
CONNECTORS (5) are supplied with the burner for connection to either a single or a
two-pipe system. Also supplied are two
ADAPTORS (3), two female 1/4” NPT, to adapt
oil lines to burner pipe connectors. All pump port threads are
British Parallel Thread
design. Direct connection of NPT threads to the pump
will damage the pump body.
F 1 0 - 8