Crestron electronic on wall speaker - Manual (Page 28)

Audio Distribution System Crestron Adagio™ AADS
⇒
⇒
⇒
Configure Keypads – Configures the source assignments of the top
six buttons of every C2N-DBF12 keypad that is connected to the
system.
Restore Defaults – Restores default settings
System Information – Provides information about the AADS such
as IP data, firmware version, and program information.
To configure the displayed option, press the SELECT button.
To exit Installer Tools and save changes to the AADS’ configuration, press
the MENU button.
Select Tuner Format Select the tuning format to specify the tuning method used by an installed AM/FM
tuner. When using the North American tuner format, the tuner will tune FM
frequencies in 100 kHz steps and AM frequencies in 10 kHz steps. When using the
European tuner format, the tuner will tune FM frequencies in 50 kHz steps and AM
frequencies in 9kHz steps.
• Open Installer Tools as described on page 23, select Select Tuner Format,
and press the SELECT button
Select Tuner Format Menu
Select Tuner Format
North American
SOURCE
ROOM
PRESET
MENU
BKLT
SCHED
DISPLAY
MORE
• To select a tuner format, press the selection control up or down to display
the desired tuner format and press SELECT. To cancel and return to the
Installer Tools menu, press the MENU button.
Configure the Network The AADS must be configured to recognize devices that communicate over Ethernet
(i.e. AAS, CEN-IDOC).
• Open Installer Tools as described on page 23, select Configure Network,
and press the SELECT button. The AADS will poll the network to find
compatible devices.
Configure Network
Install CEN-IDOC?
Yes
SOURCE
ROOM
PRESET
MENU
BKLT
SCHED
DISPLAY
MORE
• To install a CEN-IDOC, press the SELECT button and follow the
instructions onscreen. The source name “iPod” will be displayed in place of
“Source 4” in the list of sources. Otherwise, press the selection control
down to display No and press the SELECT button.
24 • Audio Distribution System: Adagio AADS Operations Guide – DOC. 6458