Crestron electronic on wall speaker - Manual (Page 31)

Crestron Adagio™ AADS Audio Distribution System
Name Sources This screen allows you to customize the name of each source displayed on the LCD.
• Open Installer Tools as described on page 23, select Name Sources, and
press the SELECT button.
Name Sources
Select Src. To Name
1: Source 1
SOURCE
ROOM
PRESET
MENU
BKLT
SCHED
DISPLAY
MORE
• To select a source to be named, press the selection control up or down until
the source to be named is displayed and press the SELECT button. To
cancel and return to the Installer Tools menu, press MENU.
Source names can be entered using any of the factory-installed source names or a
custom name.
• To use one of the factory-installed names, press the selection control up or
down to display the desired source name and press the SELECT button.
Select Source Name
Select Src. 1 Name
[AAS]
SOURCE
ROOM
PRESET
MENU
BKLT
SCHED
DISPLAY
MORE
• To enter a custom name, press the selection control up until [Custom
Name] is displayed and press the SELECT button.
Edit Source Name
Enter Src. 1 Name
Source 1a
SOURCE
ROOM
PRESET
MENU
BKLT
SCHED
DISPLAY
MORE
⇒ Move the cursor position by pressing the selection control up or down.
Select letters (upper and lower-case), numbers, or other characters by
pressing the volume control up or down until the desired letter,
number, or other character is displayed on the LCD.
NOTE: The maximum length for any source name is 16 characters.
After entering the new source name, press the SELECT button to save
the name and return to the list of sources. If all of the sources have
been named/renamed, press MENU to return to the Installer Tools
menu. ⇒
Operations Guide – DOC. 6458 Audio Distribution System: Adagio AADS • 27