Crestron electronic on wall speaker - Manual (Page 29)

Crestron Adagio™ AADS Audio Distribution System
• The AADS will then prompt you to install an AAS. To install an AAS,
press the SELECT button and follow the instructions onscreen. The source
names will be renamed as follows:
⇒
⇒
⇒ Source 1 becomes “Server 1”
Source 2 becomes “Server 2” 1,2
Source 3 becomes “Server 3” 2
1: If an AAS-2 model is detected
2: If an AAS-4 model is detected
If a CEN-IDOC is not configured and an AAS-4 is installed, Source 4
becomes “Server 4”.
If you do not want to add an AAS, press the selection control down to
display No and press the SELECT button.
• To cancel and return to the Installer Tools menu, press the MENU button.
NOTE: When installing an AAS, only one AAS can be present on the
network.
Set the Number of Rooms Set the number of rooms so the AADS does not display unused rooms during
configuration and operation.
• Open Installer Tools as described on page 23, select Set Number of
Rooms, and press the SELECT button.
Set the Number of Rooms
Set Number of Rooms
6
SOURCE
ROOM
PRESET
MENU
BKLT
SCHED
DISPLAY
MORE
• To select the number of rooms, press the selection control up or down to
display the number of rooms and press SELECT. To cancel and return to
the Installer Tools menu, press MENU.
NOTE: With an AAE connected to the AADS, the maximum number of
rooms that can be selected is 12 (when using out-of-the-box functionality).
Operations Guide – DOC. 6458 Audio Distribution System: Adagio AADS • 25