Bernina 532-2 - Manual (Page 11)

winding, turn with your right hond the handwheei release screw CO as far as possible
towards you, at the same time holding the handwheel 11 firmly with your left hand.
Slip the bobbin 20 onto the bobbin shaft IG projecting out from the stand below the
handwheel, and turn it slowly until the small pin mounted on the bobbin shaft engages
in the slot of the metal bobbin. This pin ensures that the bobbin turns with the siiuft.
tlringing the thread to the bobbin is simple. From the thread reel placed on the pin 22,
pass the thread first through the eye S located at the back, then through tlie eye 8a,
and from there downwards between the tension discs of the bobbin tensioning device 24
onto the bobbin 2C.
The motor tan then be started by a slight pressure on the knee lever or foot jilute.
Care must be taken never to fill the bobbin right to the rim. After finishing the
winding operation, tighten the handwheel release screw 60 again.
Inserting the Bobbin In the Cate and Threading tha Bobbin Thraad
Replacing Bobbin Case in Shuttle
When replacing bobbin in case, make sure that bobbin
turns in the direction of the arrow when thread is
pulled. After insertion of bobbin, pass thread through
slot 27, below tension spring 28 and allow it to come
out at the end of tension spring 20.
Insertion of the bobbin case is possible only when the
needle is in its raised position. The case is held by the
opened latch 21 as when removing it (Fig. 5).
h ;
The inder: finger and thumb of the left hand hold the hinged latch so that the bobbin
case finger 30 (Fig, 7) points upward and engages the recess in the shuttle race cover.
Then place Ihe bobbin case on the shuttle pin as far as it wilt go. Now release latch
and make sure that ii is |>roperly closed. If the hinged latch does not close completely,
thread ends or fluff have collected at the base of the shuttle pin and must be removed.
17