Bernina 532-2 - Manual (Page 48)

1) Setting of machine when uiing, ardinary zlgiag itilch
# a) Attach blindstitch foot
0 b) Deflect needle to ri^ht position
# c) Set z i g z a g knob to a stitch width between 2 and 3 according' to thickness of
material
0 d) Set stitch length to 4
0 e) Set feed dog for normal sewing.
After having threaded the machine, put the lower flat piece of material underneath
the blindstitch foot, then put the upper piece of material on top and fold it in such
manner that it always touches the elastic guide, lower the blindstitch.foot and start sc wing.
The zigzag stitch width is to set in such manner that the needle on its left deflection
is stitching through the middle of the folded piece of material, which will make the seam
invisible on the upper piece of material, when flattened. Such stitch width is, depending
from thickness of materia] used, between 2 and 3.
21 SsfUlng al machtne lor automatic blindatitching
When blindstitching with the ordinary zigzag stitch, the folded piece of material is
pierced on every second stitch; when using the automatic blindstitch cam, there are
five straight stitches between each piercing of the folded piece of material. The machine
is set as follows:
hO
V a) Attach blindstitch foot
# b) Push zigzag ornamental stitch lever G1 (Fig. 63) to the back (1-131
4 c) Put ornamental stitch selector 64 to blindstitch pattern (1)
# d) Set needle to centre position
V e) Set zigzag knob to a stitch width between 2 and 3 according to thickness of
material
# f) Set stitch length to 2, 3 or 4 according to kind of material
0 g) Set feed dog for normal sewing.
The blindstitching then is done as mentioned under 1).
01