Bernina 532-2 - Manual (Page 32)

1. Sewing the leithnnd bead.
Start the machine, then the U f t h a n d b e a d is sewn in b a c k w a r d s t it c h . A scale on
the buttonhole presser ioot serves for determining the length of the buttonhole.
After the desired length of bead has been reached, stop the machine. Always
take care that the needle is then up.
2. Sewing the first end stitches.
For this purpose take hold of the zig-zag lever 12a, give it a strong push to the
left until it comes against stop II (Fig. 3S). Then sew a few end stitches after
that, stop the machine again and set the needle up.
3. Sewing the righthand bead.
Bring the zig-zag lever 12 a back from the l e f t k a n d s t o p ¡ I to the righthand stop ¡
(Fig. S9). Start the machine again. Stop it again a few stitches before the right-
hand bead has become as long as the lefthand bead and set the needle up.
Th* stap by slap aaarlng of lha hullanhola ia now etfactod as follows:
(« )
,
- <
S !
4. Sewing the second end stitches.
Again set the zig-zag lever 12a to the stop II (Fig. 40). After a few stitches
have been sewn, stop the machine once again, and set the needle up us before.
58
KliC. 3S Fie- S9 Fis. 90
59