Hemmer, Gathering foot – Bernina 532-2 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hemmer
<Hem width mpprox,
0
*
Extras}
Gathering foot
Attach the hemmer in place
o t
the ordinary presaer foot, raising the presser foot bar
for the purpose.
fíe
.a I
Fold the edge of the material over to the desired
hem width and pass the fabric into the spiral-
type guide tongue of the raised hemmer as
far as the needle, then lower the hemmer.
When sewing, lightly guide the prefolded edge
(Fig. 21). If too much fabric enters the hem
mer, the seam will become bulgy and uneven;
if too little the hem will not be folded in
sufficiently.
Fla. iis
Put the material to be gathered under the gather
ing foot, that is to say not in the transverse slot.
Lower the gathering foot by means of the presser
foot lever and insert the piece of material, which
must remain quite flat, in the transverse slot as
far as it will go. To increase the amount of gather
ing or gauging on the bottom material hold the
top material hack - the more it is held back the
greater the amount of gathering.
If
o n l y
one layer of material has to be gathered
place the material beneath the gathering foot and
lower it. The material is gathered more or less as
the length of stitch is made greater or smaller.
10
41