Bernina 532-2 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
When the machine has been kept in a very cold room, it should be opened and placed
in a warm room about one hour before use so that it assumes room temperature and
allows the oil in the bearings to becomes liquid again.
Important Ollirtg Inalructlona
t. Excessive oiling will cause trouble.
2.
If the speed of a machine has substantially decreased, this is
generally due to excessive oiling of the motor.
3. The motor of every new machine is oiled at the factory, and need
nut be oiled during the first year.
4. After the first year, the motor requires oiling only
e v e r y
six
v i o n t k a i f t h e w a c h i v e
is m daily use, a maximum of 4-5 drops
being placed into the two oiling points marked in red. If the
machine is used
и н е е
a
w e e k ,
one annual
o i l i n g
in the second and
subsequent years is sufficient.
5. If the motor is oiled too little, this condition is shown by abnormal
noise.
ti. To oil the motor, remove the motor housing. The two diagonally
opposite nickel-plated screws below the bed plate are removed and
4-5 drops light, odorless sewing machine oil are applied to the
points marked in red on the two bearings.
7. Always make sure that all other portions of the motor are kept
free frotii oil.
8. These instructions apply to the motor only.
2Ь
27