Bernina 532-2 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjuttmtnl for Aütomalic Omamanlal Stitch Sawing
The lever SI
f o r
zigzag or ornamental stitches is placed at the right-hand side of the
top arm (Fig, 63). It projects from the slot in the plate 52. If the niachine is to he set
for control by the automatic ornamental stitch device, push lever 51 backwards, lieset
for zigzag stitches by pulling lever forward.
At the left of the zigzag lever is placed the ornamental stitch selecting lever 54 which
projects from the plate 63. This plate hears the symbols of the thirteen possible orna
mental stitches. When sewing zigzag stitches, the lever 54 with its white line on the
symbol side of the sente is set at zeio, maiked by a zigzag line, i.e. in front position.
Select an ornamental stitch ami
set lever 54 at the correspoml-
ing symbol so that the white line
thereon lines up with its mark.
This is cffeeted as follows:
Pull lever 54 to the right in
its guiding slot, displacitig it
until its tine and the stitch sym
bol line up and then release. It
will automatically he locked and
stay in this position. When dis
placing the lever, make sure that
the needle is outside tlie fain ic,
i.e. in raised position. The stitch
width adjusting knob 12 shoLikl
be set so as to show the numeral
4 in the sight opening, i.e. to
produce the largest stitch width,
H4
vvvwwwx
After threading the ma
chine, stitching can be
started in the same man
ner as ordinary sewing.
When switching back to
normal
zigzag
stitches,
place control lever in ze
ro position as described
above.
AAAAAAA/VWWW\
TTTYTTTTliTTT^i
r\r\Jr\r^Jr\^\/\/^
Slkch kiiiftti
u
I
ju
^ 0
Stitch wiUlh
4
Kltf, C5