Bernina 532-2 - Manual (Page 17)

Plain Stitch
Plain Stitching with Standard and Special Presser Foot
Exchanging Preiter Foot
Different sewing work requires more or less frequent exchange of the presser foot.
This is why the BERNINA Record Model 530-2/632-2 has been equipped with a presser
foot holding device which does not require the aid of a screwdriver but still ensures
positive claraping of the presser foot.
a ) R e m o v a l o f ¡ ‘ r e i s e r F o o l Fig. 15
The cloth presser bar with presser foot is lifted by the lifting lever placed on the rear
of the head. Now raise clamping lever 41, which engages below the damping boss 4 2
of the presser foot 43, far enough for tbe hook 44 of the clamping lever to release the
clamping boss 42 completely. The presser foot will drop automatically, or with a little
help from the cloth presser bar cone and can easily be removed.
2Я
b } W h e n r e i ) l a c ' m g I k e F r e s a e r F o o t proceed in the opposite order: After raising the
cloth presser bar by means of the lifting lever, hold the shank of the presser foot
between thumb and index finger of your left hand, and place the presser foot below
the cone of the cluth }>resser bar while the needle is raised. Now lift the clamping
lever 41 with your left hand and slide the presser foot into the cloth presser bar
cone making sure
that the screw 46
engages tbe guide
uf the presser
foot. Then depress
clamping lever so
that it will engage
below the clamping
boss of the presser
foot. Slight pres­
sure exerted on the
lever will suffice
to secure the pres­
ser foot firmly on
the doth presser
bar cone.
b'iü- lij