Aiwa SX-N332 - Manual (Page 50)

-ESHOOTING GUIO
If the unit fails to perform as it is supposed to, by following this operation manual, please check it carefully in accordance with the chart below:
Symptom Causes Solutions
There is no sound. • The power cord is not connected properly. • Correct the connection.
• An incorrect function selector button Is pressed. • Press the function selector button to select the
correct input.
• There is a bad connection between systems. • Correct the connection.
• Excessive voltage was applied to a speaker jack,
which tripped the amplifier’s voltage-protection
breaker.
• Disconnect the power cord, correct the condition,
including speaker connections, and connect the
power cord again.
There is no sound and no
indicators are lit in the display
window.
• There is a short circuit in the speaker jack.
• The breaker tripped because of connection to a low-
impedance speaker.
• Disconnect the power cord, correct the condition,
including speaker connections, and connect the
power cord again.
Sound comes from only one
speaker. • One speaker is disconnected. • Correct the speaker connection.
¡
There is constant, wavelike static. • The antenna is not connected properly.
• The receiver is not correctly tuned.
• The signal is too weak.
• Check the antenna connection.
• Correct the tuning.
• Install an outside antenna.
There is noise. • The system picks up outside noise. • Change the location or direction of the antenna.
• Turn the system to a different orientation.
• Move the system away from other electrical
appliances, like a TV or fluorescent lights, or move
the appliances.
The sound is distorted. • There is multipath distortion. • Change the orientation of the antenna.
• Replace the antenna with one that has the correct
orientation.
o
m
The tape does not run. • Deck 2 is on pause. • Press II and release pause.
The sound is off-balance. • The playback head is dirty. • Clean the head.
High sounds are too loud. • The DOLBY NR mode is set differently from when
the recording was done.
• Reset DOLBY NR to the same setting as when the
recording was made.
There are no high sounds. • A non-Dolby NR tape is being played back in that
mode.
• Turn off DOLBY NR.
• The playback head is dirty. • Clean the head.
Recording is impossible. • The erasure-prevention tab on the tape has been
broken.
• Cover the erasure-prevention hole well with tape.
• There is an incorrect connection. • Correct the connection.
• The recording head is dirty. • Clean the head.
Erasure is impossible. • The erasure head is dirty. • Clean the erasure head.
iiiiii
1
■ 5 .
□
Ü
It does not play. • The disc is incorrectly inserted. • insert the disc with the label facing up.
♦ The disc is dirty. • Clean the disc.
• There is condensation on the disc. • Wait about an hour and try again.
• The player is on pause. • Press II PAUSE to release pause.
The output sound is not stereo. • The VOCAL FADER is turned on. • Turn off the VOCAL FADER.
50