0 scanning method, 0 various scanning, 0 operation – ADI Systems AT-201 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
0
Scanning Method
Either pause scan or busy scan can be selected
•Pause scan
Pause scan ceases scanning when a signal is received
Scanning will then resume five seconds later or when the
signal disappears, whichever occurs first.
• Busy scan
Busy scan stops scanning when a signal is received, but
scanning resumes 4.5 seconds after the signal disappears
(The Transceiver is initially set to pause scan)
0 Various Scanning
This Transceiver is capable of following scans
• Dial-frequency scan
(1) 1 MHz band scan
To scan the band from one end to the other within 1 MHz
(2) Partial band scan
Scans only a selected group of frequencies
•Memory frequency scan
(1) All memory scan
(2) MS.M memory scan
NOTE:
Memory frequency scan can be operated with battery save
function as save memory scan.
0 Operation
• Dial-frequency scan
(1) 1 MHz band scan
a)
Set the Transceiver to the dial-frequency mode.
b)
Press the CA/SCAN button. A short beep tone will
be generated and the scanning will start at the
displayed frequency. The decimal point keeps
flashing during scanning operation.
c)
Press the CA/SCAN button again to cancel the
scanning.
, I h I n n
I
I
f I.LI LI
I
c)
VSCAN
i -
start flashing
/
u uln zi
I I If'-i L
I /S'4r/W I
-------,
remain turned on and
scanning cancelled
23