ADI Systems AT-201 - Manual (Page 32)

NOTE:
(1) If no frequency has been stored in memory, the
dual-watch operation is unavailable. You will hear a
low-toned short beep when you press the 1/DUAL button
informing you an incorrect entry.
(2) In dual-watch operation call frequency is considered as
one of memory frequencies. That is, you can have
dual-watch operation to listen on dial-frequency and call
frequency.
( 3 ) Dual-watch on the dial-frequency and
a memory frequency under scanning
in sequence.
( Procedure)
a) Set the Transceiver to the memory scan mode.
b) Press the 1/DUAL button while pressing the Function
button. A word “DUAL” will appear on the display to indicate
the dual-watch operation. The display will sequentially
indicate the dial-frequency and the memory frequencies
under scanning one by one.
c) Press either the C/VSCAN button or */ MR /ENT button to
cancel the dual-watch operation and to set the
dial-frequency mode. The Transceiver will be set to either
the dial-frequency mode or the memory mode depending on
the condition at which the button is depressed.
; i - i . L i U I i'-,^ ( (_
MR/ENT
disappears
r
, i j ~ ~ i n
I I I . U L I I I I _u_ u '
31