Troubleshooting – ADI Systems AT-201 User Manual
Page 54
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
Q: The frequency display is weak.
A:
The battery voitages are low. Replace the batteries.
Q: The unit does not receive.
A:
Press the squeich button and see if any sound comes out
of the speaker.
A:
Isn’t the squelch control rotated fully clockwise?
Rotate back the squelch control counterclockwise for the
threshold setting.
A:
Isn’t your Transceiver set for tone squelch operation?
(when CTS145 is installed.)
Release the tone squelch operation.
A:
Isn’t the volume control rotated fully counterclockwise?
Rotate back the volume control for comfortable listening
level.
A:
Isn’t your Transceiver set for paging or code squelch
operation? (when DTF145 is installed.)
Release the paging or code squelch operation.
Q: The Transceiver does not transmit.
A:
Doesn’t the RF output indicator light dark when pressing
the PTT button?
Replace batteries.
A:
Isn’t “RL’ indicated on the display?
Press the B/PWR/PL button while pressing the function
button to release the PTT Lock function.
Q: The displayed frequency cannot be changed.
A:
Isn’t “F.L” indicated on the display?
Press the 6/LOCK button while pressing the Function
button to release the Frequency Lock function.
Q: No beep sound is generated.
A:
Isn’t the buzzer disabled?
Press the 0/SET button while pressing the Function button
and then press the 0/SET button to enable the buzzer.
Q: The Transceiver appears to receive oniy the strong
signals.
A:
Is your antenna installed properly?
Check it and install it properly.
A:
Isn’t the squelch control rotated fully clockwise?
Rotate back the squelch control for the threshold setting.
53