Power on-off switcha^olume control, Squelch control, Rotary channel selector – ADI Systems AT-201 User Manual
Page 8: 0 external speaker jack: s, External microphone jack: m, Antenna jack: ant, Transmission/battery indicator, Function button, Ptt button
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
© Power On-OFF SwitchA^olume Control
This is to turn the power on and off and to control the
volume. Rotate the control clockwise to turn the power
on,and rotate it clockwise further to increase the volume.
The Squelch Off button should be held depressed or the
Squelch Control rotated fully counterclockwise while
controlling the volume.
© Squelch Control
This is to control white noise. Rotate it clockwise slowly
and set the control where the noise stops.
NOTE:
(1) DO not rotate the control clockwise too far.
(2) The control should be placed where the white noise is not
heard during following operations; Scanning, Dual-Watch,
Battery-Save, Paging and Code Squelch.
(3) Adjust the control with the channel which is not receiving
the signal.
© Rotary Channel Selector
This is to select the transmit/receive frequency. It is also
used to change the tone frequency, channel step and
memory address number. Rotate the selector clockwise
to increase the frequency and counterclockwise to lower
it. The interval by which the frequency changes is referred
to as "Channel Step". The Channel Step which is
initially set to 10kHz can be changed to 5, 12.5, 20, 25 or
50kHz. (Refer to Changing the Channel Step, contents 14).
0 External Speaker Jack: S
This is to connect Microphone/Speaker or Head Set with
PTT. Any other external speaker with 8 ohm load or an
earphone can be connected. A built-in speaker is disabled
when an external speaker is connected to this jack.
© External Microphone Jack: M
This is to connect Microphone Speaker Head Set with PTT.
© Antenna Jack: ANT
This is a BNC connector to connect the attached helical
antenna.
© Transmission/Battery Indicator
This indicator lights up in red when the transmitter is
keyed. When weakened batteries, it becomes darker
recommending battery replacement.
© Function Button
Special functions are available by pressing each button
on the front panel with the function button held depressed.
® PTT Button
For transmission, press this button and speak into the
m i c r o p h o n e . Release the PTT button to receive.
When operated with Head Set with PTT, press the PTT
button on Head Set to transmit.