ADI Systems AT-201 - Manual (Page 52)

Automatic Repeater Offset:
1. Select VFO mode (No “M” in display).
2. Press [FUNC]+[2], a+-will be displayed. The proper
repeater + or - offset will now be set by the radio, Repeat
the process to toggle off the automatic repeater offset.
3. The offset frequencies for auto repeater:
• 144.00 to 145.095 MHz : 0 (simplex)
-0.6 KHz •145.10 to 145.495 MHz
•145.50 to 145.995 MHz
•146.00 to 146.395 MHz
•146.40 to 146.595 MHz
•146.60 to 146.995 MHz
•147.00 to 147.395 MHz
• 147.40 to 147.595 MHz
• 147.60 to 147.995 MHz
0 (simplex)
+0.6 KHz
0 (simplex)
-0.6 KHz
+0.6 KHz
0 (simplex)
-0.6 KHz
23 Exchange the Transmit and
Receive Frequency during
Repeater Operation
[8/REY/TButton]
This feature allows you to exchange the transmit and receive
frequencies during repeater operation. You can check if the
other station is accessible.
(
Procedure)
a) Set the Transceiver to the repeater mode.
b) Press the 8/REV/T button again while pressing the
Function button or “+” on the display will start flashing
and the transmit and receive frequencies will start flashing
and the transmit and receive or “+” on the display will start
flashing and the transmit and receive frequencies will be
reversed.
c) Press the 8/REV/V button again while pressing the
Function button or “+” on the display will stop flashing
and remain turned on. The transmit and receive
frequencies will be reversed again and the regular
repeater-mode will be returned.
NOTE:
This feature is only available during repeater operation
and when the transmit frequency is within the operating
frequency range.
51